東煒庭電機工業有限公司 - Operation And Installation Of Gear Reducer

Operation And Installation Of Gear Reducer

USAGE AND INSTALLATION

■ Make sure that the model type,horse power,shaft direction,reductiondirection and revolutions ofinput/output shafts match with
each other.
■ Check oil level first and make sure the level keeps abeve half of oil gauae.

PLACE

■ The gear reducer shall be installed in aglat and firm base.
■ The inatallation environment shall be dry and well ventilated with ambient temperature 0℃-40℃ Abnormal high or low
temperature shall be indicated.

CONNECTING METHOD

■ If coupler is used to connect or output shaft,make sure they are jirmly fixed and paralleled,The base shall be anchered with
proper bolts.
■ All of the components shall br properly assembled to shaft.Avoid hammering and ever tight assembly which could damage
the bearing.
■ The pulley,chain pulley and gear shall beassembled as close to the bearing as possible to minmize the curving stress.
The chain pulley andbelt pulley used to connect the output shaft shall be properly chosen(withinh 6 times as large as the
surface.The pplication of anti-rust paint can keep the shaft from rusting.

MOTOR

■ The voltage variation over 10% could cause motor to burn out and reduce the torqur of output shaft.
■ Motor is subject to damage due to overload.
■ Improper commection could cause motor to burn out.
■ High-moisture environment could cause the brake of motor rusted and disabled
■ An appropriate motor shall be applied with the frequency chnverter while the liw frequency is required usual condition.

Main Menu