Solutuins And Reasous For The Genral Faults Of Reduction Gears
| FAULT DESCRIPTION | REASONS | SOLUTIONS |
Overheation |
■ Overload ■ Lash load big or reciprocate to start ■ Motor exterior greasy dirt too much ■ Voltage low load operation ■ Improper cinnection between driving shaft and the transmiission device. |
■ Adjust to proper loading. ■ Use larger reduction ■ Wash motor exterior ■ Adjustment is to normal voltage ■ Adjust to proper position |
Noise |
■ It is serious that overload operation cause gear wear ■ Bearing damaged or too large clearance. ■ In generator discrepant thing ■ Lubricant oil shortage or deterioration. ■ Improper connec tion between driving shaft and the transmission device. ■ Bolt loose. |
■ Adjust to proper loading of Use larger reduction gears. ■ Replace bearing. ■ Tale out foreign objects. ■ Fill in adequast lubricant oil as indication. ■ Adjust to proper position. ■ Tighten bolt. ■ Fix transmission device properly. |
Oil leakage |
■ Oil seal damaged ■ Too much oil. ■ Deceleration machine screw pine is taken off ■ Outside shell fractured. |
■ Replace oil seal ■ Fill in adequast lubricant oil as indication. ■ Tighten screw. ■ Tighter bolt.Replase outer shell |
Driving Shaft Cannot rotate |
■ Overload ■ large Impact loading. ■ Motor out of order of incorrect wiring. ■ The pine of power supply cord is taken off ■ Single-phase starts capacity to damage |
■ Adjust to proper loading. ■ Use larger reduction gears. ■ Restore motor,join wiring correctly. ■ Join power supply cord. ■ Change capacity. |
OTER：1.The above items are general fault descripions,In case of other kinds,please cpntact woth us tp pbtain most correct
services.
